DAPAudio Cesium 200 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Penguat DAPAudio Cesium 200. DAPAudio Cesium 200 11 halaman.

Maintenance

The Cesium amplifier requires almost no maintenance. However, you should keep the unit clean.

Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid.

Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp cloth.

Make sure connections are thoroughly dry before linking equipment or supplying electric power.

Please clean the dust filter every 15 days.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the fuse

burns out, the product will not function whatsoever. If this happens,

1. Unplug the unit from electric power source.

2. Insert a flat-head screwdriver into the slot in the fuse cover. Gently pry up the fuse cover.

3. Remove the broken fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover.

Be sure to use a fuse of the same type and specification. See the product specification label for details.

Dap Audio Cesium 200 and 300

This troubleshooting guide is meant to help solve simple problems.

If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates

properly, do not carry out following steps.

If the amplifier does not operate properly, refer servicing to a technician.

1. If you experience low output or no output at all, unplug immediately.

2. Check the fuse, power from the wall, all cables etc.

3. If all of the above appears to be O.K., plug the unit in again.

4. If you are unable to determine the cause of the problem, do not open the amplifier, as this may damage

the unit and the warranty will become void.

5. Return the amplifier to your Dap Audio dealer.

follow the directions below to do so.