DAPAudio DSA-600 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat DAPAudio DSA-600. DAPAudio DSA-600 18 halaman. Dsa-series

Backpanel

10.

AC Inlet.

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the power switch (9) to

operate the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

11. Output B Speakon Connector.

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

12. Output A Speakon Connector.

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

13. Channel B In/Through Connectors

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

14. Stereo/ Bridge Switch.

The two-position, Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo or Bridged Mono Mode.

15. GND Switch.

To eliminate ground loops, put the switch in "OFF" position.

16. Channel A In/Through Connectors

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

17. Air cooling windows

This part is the air cooling window. Don't obstruct it.

Fig. 3