DAPAudio ZA-240VTU Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Penguat DAPAudio ZA-240VTU. DAPAudio ZA-240VTU 19 halaman.

Connecting Outputs.

Speakers are connected using terminal connectors. See the examples below and following page.

You can use as many speakers as you want as long as the total impedance matches the amplifiers

output.

Example 1: using the 4Ω output with two 8Ω speakers.

Example 2: using the 4Ω output with four 4Ω speakers

Example 3: using the 8Ω output with two 4Ω speakers.

In a low impedance system, the total speakerload should always match the amplifier

impedance This to avoid overloading the amplifier.

The total speaker power should be at least the power of the amplifier to avoid damage to the

speakers.

If using either the 70V outputs or the 100V outputs, note that all speakers should be wired in parallel.

The total power of all speakers summed together should never exceed the total power of the

amplifier in a 70V or a 100V system!

Fig. 5

Fig. 6

Fig. 7