DAPAudio IMIX-7.1 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Mixer Musik DAPAudio IMIX-7.1. DAPAudio IMIX-7.1 16 halaman. 7 channel 2u install mixer

Halaman Cetak

IMIX 7.1

Functions

3/4/5. Equalizer section (high/mid/low)

The microphone channel's equalizer section allows shaping of the incoming audio signal. All mono input

channels are fitted with 3-band EQ. The high (5) and low (3) shelving controls have their frequencies fixed

at 12KHz and 80Hz respectively. The mid (4) range control has a peaking response frequency at 1KHz. All

3 bands have up to 12dB cut and boost, with a centre detent for off. Turning an Equalizer control to the

right amplifies the frequency range, turning to the left attenuates the signal. Minor changes to the

Equalizer control usually produce the best results. Try to avoid excessive enhancement of the MID band.

Talkover on button

Use this switch to activate the talkover function.

Power LED

The green power LED lights when the Sessionmix is turned on. If after switching the device on, the LED

does not light, make sure that the AC adapter is connected properly. If the LED still doesn't light up after

everything is connected right, please contact your DAP audio dealer.

MIC level control (Mic 1/2)

Controls the volume of the corresponding microphone channel.

Talkover amount control

Use this control to set the amount of signal reduction for the line channels 1-5 when spoken in the

Microphone. Use this control to set the amount of signal reduction for the line channels 1-5 when spoken

in the microphone.

10. Talkover time control

This control allows you to set the time for returning to the normal volume level of the line channels 1-5 if

you stop speaking in the microphone.

11. Mute button

Use this switch to mute the according Microphone channel.

Ordercode: D2350

1. Mic input connector

Electronically balanced combo-type input for

connecting low impedance microphones. The input has

extremely low noise and low hum. When connecting a

microphone make sure that the pin assignment is

correct. Always make sure to read the manual of the

microphone you want to connect. The XLR- input is not

suitable for connecting an additional mixing console, FX-

unit, etc. You have to use the line (48-52) inputs, when

connecting this kind of equipment.

Note: When connecting signal sources, please make

sure the corresponding channel faders and the master

faders are at their minimum settings. Otherwise

unpleasant plug-in noise can occur.

2. Peak LED

The Peak LED shows peak levels in a channel's incoming

signal level. If the peak LED frequently blinks or constantly

lights, the corresponding channel is likely to enter

clipping and you have to reduce the input's

amplification using the level (8) control. The peak LED

lights at a level of 8 dB below clipping. Make sure that

the peak LED lights only briefly during dynamic peaks.