Duratech LINK Touch DLT10-TW Manual - Halaman 12

Jelajahi secara online atau unduh pdf Manual untuk Kontrol Jarak Jauh Duratech LINK Touch DLT10-TW. Duratech LINK Touch DLT10-TW 14 halaman.

How to upgrade the Link Controller control board

To upgrade the Link Controller, the following steps need to be taken:

Switch of the power of the Link Controller.

2. Remove the Lora module from the control board.

3. Insert the SD card into the SD Card slot on the control board.

4. Power up the Link Controller

5. The green LED will be lit and the blue led will start ﬂ ashing.

6. When the green and blue led remain solid, the fi rmware has been

upgraded.

Power down the Link Controller.

8. Remove SD card from SD card slot.

9. Insert the Lora module again.

10. Power up the Link Controller.

11. The Link Controller is now LinkTouch™ compatible.

Lora module

Safety information

Precautions for Cleaning, Transport and Storage

- Use a soft, damp cloth to clean the exterior of the LinkTouch

Do not use cleaning tissues or chemical substances which might

damage the surface.

- This LinkTouch

service the LinkTouch

a authorised technician.

First use

SD card slot

contains no user serviceable parts. Do not attempt to

yourself. Repair service should be performed by

Do NOT drop

The LinkTouch

the LinkTouch

is NOT water

proof

Fully charge the LinkTouch

before using the device

The LinkTouch

is NOT dust proof