Duratool D03168 Panduan Cepat
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Pistol Solder Duratool D03168. Duratool D03168 2 halaman.
Halaman Cetak
IMPORTANT SAFETY INFORMATION
•
When using electrical appliances basic safety precautions should always be
followed.
•
Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
•
Do not operate the appliance with a damaged plug or cord, after a malfunction or
after being dropped or damaged in any way.
•
If the supply cord is damaged, it must be replaced by a qualified engineer in order
to avoid injury or hazard.
•
The soldering iron must be placed on its stand when not in use.
•
Ensure there is sufficient space and ventilation around the appliance to allow the
escape of heat and/or fumes.
•
Never place the product or part of it in water, or operate if your hands are wet.
•
Wear appropriate clothing and safety goggles while soldering.
•
Soldering work must be conducted on a stable, non-combustible surface.
•
Do not touch any metallic parts near the soldering tip/nozzle.
•
Do not leave the soldering iron unattended while it is switched on.
•
Wash your hands thoroughly after working with solder.
•
Make sure the power switch is in the "off" position and disconnect the plug when
the unit is not in use.
•
Before storage, ensure the power is off and and allow the station to cool down to
room temperature.
ABOUT
•
The soldering station is designed especially for lead-free soldering.
•
The soldering iron heats up from room temperature to 350°C in about 30 seconds.
•
The soldering iron tool is controlled automatically by the micro-processor.
•
The digitial control electronics and high-quality sensor heat exchange system
guarantee precise temperature control at the soldering tip.
•
The soldering iron's high powered and slim design makes this iron suitable for fine
soldering work.
•
The heating element is made of PTC and the sensor on the soldering tip can
control the soldering temperature quickly and accurately.
Soldering Station
Model: D03168