Belimo FS Series Penggantian - Halaman 15
Jelajahi secara online atau unduh pdf Penggantian untuk Mesin Belimo FS Series. Belimo FS Series 19 halaman. Replacement of multiproducts motors
Juga untuk Belimo FS Series: Petunjuk Manual (20 halaman), Lembar Instruksi (18 halaman)
Halaman Cetak
- 1. Table of Contents
- 2. Code and Standard Issues
- 3. NFPA 80 (Fire) & NFPA 105 (Smoke )
- 4. Local Code Approval
- 5. Cross Reference
- 6. Fire & Smoke Damper Technical Details
- 7. Replacement Instructions
- 8. Mounting Methods
- 9. Linkage Mounting
- 10. Miscellaneous Parts
- 11. Thermal Sensor Replacements - BAE165 US
- 12. Auxiliary Switches
- 13. Wiring
- 14. Building Official/Fire Marshal Notification Form
Miscellaneous parts
Should they be needed, Belimo carries a range of parts. Ball joints and 5/16" rods are available from
most distributors.
KH8
KG8 3/8"
KG6, KG10A ¼"
SH8 (not shown – see picture page 9). Push-rod for KG6 & KG8 ball joints. 5/16" 36" long
Use SH10 3/8" rods for GMB and dual FSAF or FSNF linkages. 5/16" can bend under heavy loads.
Thermal sensor replacements – BAE165 US
Air Balance Honeywell ML&MS Types to Belimo FSxx
Where the crank arm on the jackshaft is broken or not of
the type needed, the KH12 fits over the shaft without
removing it. Zinc plated steel. Slot is for the KG10A ball
joint. V-bolt fits ¾" to 1" (20 to 25mm) shafts.
KH-6. Zinc plated steel. For shafts 3/8" to 11/16" Uses KG6
ball joint. Slot width 1/4"
KH-8. Zinc plated steel. For shafts 3/8" to 11/16" Uses KG8
(90 degree) or KG10A ball joint. Slot width 21/64"
Damper blade clip and ball joints for blades
typically 3.5" in width. Typically the actuator or
rod to shaft is in front of blade.
ZG-DC1
Damper blade clip and ball joints – typically
used for 6" wide blade control dampers.
Typically the ctuator or rod to shaft is above or
ZG-DC2
below the damper.
Belimo BAE165 US
Where existing sensor is defective or one must be added, the
165°F primary sensor may be used.
Original equipment is recommended although not strictly
required by code. UL does not regulate replacement or repair.
See NFPA 80 or NFPA 105.
March 2018
15