DAPAudio D3220 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Sistem Pembicara DAPAudio D3220. DAPAudio D3220 14 halaman.

Halaman Cetak

Set Up and Operation

The new Soundmate 2 MKII is a further development of the immense popular Soundmate 1, which

became a much used system among entertainers and musicians. The Soundmate 2 MKII has the same

critical user-specs as the Soundmate 2, namely: compact, yet powerful, plug-and-play, roadproof and of

course a neutral sound with an extra bass-punch. The amplifier-section is build into each subwoofer and

consists of 3 separate power-amplifiers. It's easy to set up.

The satellite

The SoundMate Active I MKII satellite is designed to produce a full spectrum of sound. The satellite is

equipped with a 8" LF loudspeaker and 1,375" HF driver with a horn with a dispersion of 90˚x60˚.

The subwoofer

Feel the bass with this 15" basscabinet. The cabinet is powered through a powerful 400W amplifier for the

Subwoofer and a 2x130W amplifier for the Satellite. The castors makes the unit easy to move and thanks

to this feature it is a real road proof system.

It's easy to set up; All you have to do is set up the system components, connect the signal-carrying

cables and power cords and you're ready to roll. The set comes with ALL necessary accessories: cables

and even dust-/raincovers!!!

Linking Satellites / Subwoofers

Connect the cables coming from the mixer to the Combo INPUT socket of the subwoofer. Depending on

the mixer's output sockets use either a jack or XLR cable. Connect a speakon cable to the Speakon

output (11) of the subwoofer and to the Speakon input of the satellite.

Note:

Do not supply power before

all components of the system are

set up and connected properly.

Make sure that the SoundMate system is always the last component, which is switched on! When shutting

down, the SoundMate should be the first system, which is switched off.

Below you will find a short description of the features from the SoundMate Active 1 MKII :

To Satellite (1+6)

This output is used to connect the Satellite Speaker.

Input (2+4)

The input equipped with 3 pole XLR/ jack combo socket is electronically balanced to accept the (line)

signal from any mixing console.

Full Range Through (3+5)

This parallel output allows you to connect more bass-cabinets together as well to connect other systems

such as monitor power amplifiers, individual components etc.

Power Switch (9)

Do not supply power before the whole system is set up and connected properly.

An external fuse protects your system from any damage caused by electrical failures.

IEC Power Inlet and Fuse (7+8).

This connector is meant for the connection of the supplied main cord. Connect one end of the power

cord to the connector, the other end to the mains, then turn on the Power switch (1) to operate

the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains. Replace the fuse only with a fuse of same specification (T6,3A).

Ground Lift (10)

When this button is pressed, it separates the signal ground from the chassis ground, enabling you to

eliminate potential ground loops or low-frequency hum.

Hi-Mid Limiter LED (11+13)

Lights if the Hi-Mid Limiter circuit is active.

- Green LED: Signal

- Orange LED: Soft Limit

- Red LED: Hard Limit