DAPAudio entertainer mobile set basic Panduan Produk - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Produk untuk Sistem Pembicara DAPAudio entertainer mobile set basic. DAPAudio entertainer mobile set basic 16 halaman. 2x150 watt 8 omh

Halaman Cetak

Patch panel

20. Mono line input jack

1/4" balanced input jack is suitable for devices with line outputs like keyboards, drums, outboard effects,

etc. Accepts both balanced and unbalanced cables.

21/22/ 29/ 30. Stereo line input

1 / 4", 1/8" TRS jacks or RCA jacks for line level devices such as tape recorders, CD players or other stereo

equipment.

23. Tape out

The Tape out provides a mix output which is independent of the Master Level (13) control. Connect a

device, such as a cassette or DAT recorder. All adjustments to the input level, channels EQ, and DSP can

be heard through the REC output. You can only adjust the record level using input controls on your

recording equipment.

24. Eff/aux send

Use this output in combination with the Aux Return (32) to connect an external effect device. Using an

external effect device in your aux effect loop will run this effect in parallel with the internal effects.

25/27. power and protect indicators

The green Power LED indicates the unit is switched on.

The red Protect LED Indicates that the power amp is in Protect mode (speakers disconnected by the

output relay).

26. Clip indicators

The orange LED indicates the clipping status for the left and right amplifier outputs.

28. Mic input jack

XLR balanced low impedance microphone input.

31/32. Amplifier send/return jacks

Each channel of the amplifier has a send and return jack. These jacks offer an insertion point. The (stereo)

effect loop is situated between mixer and poweramp (before EQ and master section).

33. Aux return

Use this output in combination with the Aux Send (23) to connect an external effect device. Using an

external effect device in your aux effect loop will run this effect in parallel with the internal effects.

34. Foot switch

The foot switch connector allows you to mute the internal DSP section. The input accepts a standard ¼"

jack shorting the tip to the sleeve will mute the DSP section.

35/37. Speaker output

Connect the Entertainer Mobile Set Basic speakers using the supplied Speakon cables.

36. Power switch

Do not supply power before the whole system is set up and connected properly.