Duratuf PG88 Manual Petunjuk Perakitan - Halaman 15

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf PG88. Duratuf PG88 17 halaman.

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Garrison timber floor can then

be fitted on top of the Base Plate if required.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

FITTING A GARRISON FLOOR KIT (OPTIONAL)

• Position the Floor Joists centrally between the side

Base Plates and skew nail each end with two 75mm

nails.

• Check that the shed is sitting level and square . Check

that the diagonal Bottom Plate measurements are the

same. This ensures that the shed base is square.

• Place the Floor Boards in position. (You may need to

cut the last Floor Board to the correct width using a

Skill Saw.) Nail each Floor Board in, using two 50mm

nails each end and two nails into each floor joist.

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as

shown.

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS THOROUGHLY. FAILURE TO DO THIS

WILL RESULT IN CORROSION AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF GARRISON SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE