Duratuf Sentry Shed SL1507 Manual Petunjuk Perakitan - Halaman 12

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf Sentry Shed SL1507. Duratuf Sentry Shed SL1507 15 halaman.

Halaman Cetak

ROOF ASSEMBLY

SELECT:

3 x 0.885 Roof Sheets

1 x 1.555 Spouting

2 x 0.885 Barges

16 x 50mm Roofing Screws

20 x Rivets

4 x 50mm Clouts

STEP 1:

• Ensure Shed is sitting level and square.

• Lay Roof Sheets on the Top Plates (with slots at front).

• Rivet sheets together at overlaps with 1 x rivet per join.

STEP 2:

• Position the Roof Sheets with front overhang of 130mm at

each front end (fig. 1).

• Using 4 x 50mm Clouts, predrill and nail the Roof Sheets

to the Top Plates through the ribs, at each corner, ensur-

ing ribs on the Roof Sheets line up with ribs on the Wall

Sheets (fig.2).

STEP 3:

• Ensure the Front and Back Top Plates are straight.

• Screw the roof sheets to the front & back Top Plates,

using 1 x Roofing Screw per rib. (fig.2).

STEP 4:

• Place barge flashings on roof at end of shed ensuring

the diagonal trimmed end is at the front.

• Rivet the Barge Flashings to the roof and the side wall,

using four rivets on top of barge and four into the side

(fig.3).

STEP 5:

• Place spouting in position and rivet to Barge Flashings at

each end and rivet to roof sheets (1 Rivet per 1 Sheet).

IMPORTANT

Use 50mm Clouts only on outside ribs covered by Barge flashings. Predrill

holes using a 3.5mm drill bit. Use Roofing Screws on all other ribs.

Ensure screws are not overtightened as this can damage the seals and

cause the shed to leak.

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR ROOF

PANEL

Assemble as below, making sure that the Clear Roof Sheets overlap the

standard roof sheets on both sides. Pre drill and fasten with the 50mm roof-

ing screws provided.

TOP PLATE

BACK WALL

BOTTOM PLATE

SIDE

WALL

Pan

X 4

Barge

X 4

Spouting

SIDE

WALL

FRONT WALL

fig.1

Rib

fig.2

fig.3

fig.4