Duratuf Sentry Shed SL1507 Manual Petunjuk Perakitan - Halaman 8

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf Sentry Shed SL1507. Duratuf Sentry Shed SL1507 15 halaman.

Halaman Cetak

ASSEMBLE SIDE PANELS

SELECT:

2 x 1.810 Wall Sheets

2 x 1.810 1 Pan Wall Sheets

2 x 0.685 Top Plates (Red)

2 x 0.685 Bottom Plates (Green)

32 x 30mm Galv Clouts

4 x Rivets

STEP 1:

• Lay out 1 x Top plate and 1 x Bottom plate on a flat surface as shown

(corner cut-outs to face outwards).

Bottom plates are critical to ensure wall panels fit together.

STEP 2:

• Place 1 x 1.810 wall sheet and 1 x Pan wall sheet on top of timber

plates, with sheets flush with each other.

STEP 3:

• Nail wall sheets to the Top Plate at each end making

sure that the top of the sheets are flush with the top of

the Top Plate and the sides of the wall sheet overhang

the Top Plate by approx 15mm as shown.

• Check that the Top Plate is straight then nail along the

wall sheet to the Top Plate, two clouts per pan (see

fig. 1).

Std Shed — Bottom Plate will protrude below wall

sheet by approximately 10mm.

Raised base plate shed — Wall sheet will protrude

below the Bottom Plate by 20mm

STEP 4:

• Nail the wall sheets to the Bottom Plate at each end ensuring each

side of wall sheets overhangs the end of Bottom Plate by 15mm.

Check that the distance between the Top and Bottom Plates is

correct. (As per diagram in step 1)

• Check that the Bottom Plate is straight then nail the wall sheets to

the Bottom Plate, two clouts per pan (see fig. 1).

Repeat with second side panel ensuring Top Plate is positioned in

the OPPOSITE direction to the first side panel, as shown.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

Measurements between Top and

15mm

CLOUT

RIB

PAN

TIMBER PLATE

fig.1

1775mm

1798mm

TOP PLATE

1775mm

BOTTOM PLATE

TOP PLATE

RIVET

BOTTOM PLATE

15mm

TOP PLATE

BOTTOM PLATE

15mm

TOP PLATE

Second Side

Panel

1775mm

BOTTOM PLATE

1798mm