Duratuf SG2520 Manual Petunjuk Perakitan - Halaman 13

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf SG2520. Duratuf SG2520 16 halaman.

Halaman Cetak

ROOF ASSEMBLY CONT...

STEP 3:

 Ensure shed is sitting level and square.

 Beginning from the left hand end (looking from front) centralise the Roof sheets on the Ridge Beam.

 Ensure that the Roof is tight against the Gable Wall Sheets. Nail 1 x 40mm Weatherseal nail through the Pan into

the Ridge Beam.

 At the back left hand corner, (from front) line up the ribs on the Roof Sheet with the ribs on the Wall Sheet then

using 1 x 40mm Weatherseal nail, fix Roof Sheet through the pan into the Top Plate. Repeat at the front

STEP 4:

 Centralise the Roof at the right hand end with the Ridge Beam.

 Using 3 x Weatherseal nails, fix roof sheet to the Ridge Beam and front & back

Top Plates.

 Ensure that the Ridge Beam is straight, Nail roof sheets to ridge beam at each

overlap, through the pan using 5 x Weatherseal nails.

 Ensure the Front and Back Top Plates are straight. Nail the roof sheets to the

front & back Top Plates, using 1 x nail per pan (fig.1).

STEP 5:

 Rivet the 2 ridge flashings together using 4 rivets,

so total flashing is 2.550m long. Rivet the Ridge

Flashing to the centre of the roof using 8 x rivets

as shown (fig.2).

STEP 6:

 Place barge flashings on roof at end of shed ensuring the

diagonal trimmed end is facing out.

 Rivet the Barge Flashings to the roof and the side wall,

using four rivets on top of barge and four into the side

(fig.3).

STEP 7:

 Place spouting in position and rivet to Barge flashings at each

end and rivet to roof sheets (1 rivet per 1 sheet). Repeat with

remaining spouting.

SIDE

WALL

fig.1

fig.2

TOP PLATE

BACK

WALL

BOTTOM PLATE

SIDE

WALL

RIDGE BEAM

FRONT WALL

fig.3

X 4

Barge

X 4