Duratuf KIWI MK1A Manual Petunjuk Perakitan - Halaman 10

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf KIWI MK1A. Duratuf KIWI MK1A 16 halaman.

MK1A DOOR JAMB & CORNER FLASHINGS

Step3: Measure and cut Doorstep Flashing (106) to

fit in between Door Jambs. Position the Door-

step Flashing in between the Door Jambs at

bottom of doorway, nail through top of flashing

using three 30mm Clouts. Repeat with the

Overdoor Flashing (105).

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper will

need to be supported by netting or roofing twine.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be neces-

sary to temporarily brace the shed with pieces of timber from the packaging.

Step 2: Position first Roof Sheet centrally over Ridge

Beam on the right hand end of shed with the

LIP on the left hand side. (For sheds with a

Clear Roof Panel, go to the next page). Posi-

tion the next Roof Sheet. Ensure it overlaps

correctly then rivet sheets together, 100mm

and 600mm down from the centre on both

sides. Fit remaining Roof Sheet.

Step 3: Starting from the left hand end, centralise

Roof on Ridge Beam. Ensure Roof is tight

against end Wall Sheets and nail one 40mm

Weatherseal through Lip into the Ridge

Beam. At the back, line up Ribs on the Roof

Sheet with the Ribs on Wall Sheet. Using

one 40mm Weatherseal, nail through Lip into

Top Plate. Repeat at the front.

Step 4: Centralize Roof at the other end and nail

through Pan into Ridge Beam and Top

Plates. Ensure Ridge Beam is straight, then

nail one 40mm Weatherseal into Ridge Beam

beside each overlap (one nail per sheet). At

the back, set up a String Line in centre of

Top Plate. Ensure Top Plate is straight and

nail off, using one 40mm Weatherseal per

Pan. Repeat at the front.

Step 4: Fit remaining three Corner Flashings over

MK1A ROOF

corner Ribs and rivet in place using six riv-

ets per flashing. When fitting right hand Cor-

ner Flashing on the front wall, ensure it is

parallel with the Door Jamb.

Note: MK2A shown

LIP