DURAVAC CVWM510 Panduan Operator - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Operator untuk Penyedot Debu DURAVAC CVWM510. DURAVAC CVWM510 14 halaman. Wet/dry vacuums

LIQUID VACUUM OPERATION

LIQUID VACUUMING

WARNING:

BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED

'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES,

VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT

ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,

ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;

COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS

FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.

WARNING:

DO NOT PLUG POWER CORD INTO POWER OUTLET, MAKE SURE PLUG IS

DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.

IMPORTANT!

When vacuuming large quantities of liquids, we recommend that you remove the vacuum

from the mounting rack and put it on the floor. The vacuum can be heavy when full of liquids and may be

difficult to remove from the rack.

1. Verify that the power cord is disconnected from the outlet. Verify that the container is clean and free of

dust and dirt. (fig. 1)

2. Remove cartridge filter, then carefully install the foam sleeve filter over the filter cage and place the

power head back on the container. (fig. 2) See filter installing instructions on page 11.

DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.

OPERATING INSTRUCTIONS – WET VACUUMING

3. Fit the desired nozzle to the vacuum hose. (fig. 3)

4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet. (fig. 4)

5. For large amounts of liquid vacuuming, it is recommended to place the vacuum on the floor. Turn the

motor on by flipping the switch on the power head to the 'I' ON position or flip the switch to the Remote

Control Position and use the 'I' ON button on the remote control. (fig. 5 & 6)

CAUTION:

DO NOT SUBMERGER THE REMOTE CONTROL INTO LIQUIDS.

6. After wet vacuuming, turn the machine off and remove plug from power supply. To prevent the risk of

possible mildew, empty the container, clean and dry the inside and outside of the container, and remove the

foam filter and allow to air dry before storage.

IMPORTANT!

When vacuuming large quantities of liquids, do not immerse the nozzle completely in the

liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve

that stops the suction action when the container reaches its maximum capacity. You will notice an increase

in motor speed. When this happens, turn off the machine, disconnect from power supply, and empty the

liquid into a suitable receptacle or drain. To continue vacuuming, refit the power head to the container. After

wet vacuuming, turn the machine off and remove plug from power supply. To prevent the risk of possible

mildew, empty the container, clean and dry the inside and outside of the container, and remove the foam

filter and allow to air dry before storage.

REMEMBER!

The foam filter must be removed after wet vacuuming, and a cartridge filter must be

installed before dry vacuuming again.