DARCHE Intrepidor 2 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Tenda DARCHE Intrepidor 2. DARCHE Intrepidor 2 13 halaman. Roof top tent

ATTACHING MOUNTING CHANNELS

1. Remove the Roof Top Tent from the carton and place on a clean surface. Observe the

top surface. If it has four holes in the center area of the base, then this is the side which

will receive the mounting channels. Otherwise you are looking at the surface which will

receive the ladder. Open tent to gain entrance to interior and remove contents.

Contents:

1 x Ladder

(2 for the HV2200)

Mounting channels , 1 x Mounting Accessory Bag.

2. After removing the contents, close the Roof Top Tent, so the channel mounting surface

is facing upward exposing the pre-drilled mounting holes.

3. Using the four supplied 40mm Steel M6 bolt, slide your hand between the base

and mattress, and insert the bolts with the 50mm washers into the pre-drilled holes.

4. Place mounting channels on exposed bolts according to the orientation of your Roof

Top Tent.

5. Slide the M6 Nyloc Nut into the inner slot in the center of the mounting channels, until

they are aligned with the bolts sticking through the base. Tighten the bolts firmly from

below, using the supplied 10mm wrench. If you chose a side mounted orientation, you

will notice that the mounting channels extend (20cm) beyond the edges of the base. You

will need to mark each channel where they extend beyond the tent base and cut the

mounting channels so they fit within the tent base. Fasten mounting channels to base as

described above.

, 1 PVC Transit Cover, 6 x Window Rods, 2 x