4-Max SpinRay Petunjuk Bangunan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Bangunan untuk Mainan 4-Max SpinRay. 4-Max SpinRay 8 halaman.

Building Instructions for 4-Max SpinRay

Start With Elevons

Lay a piece of cling film on a flat surface.

Apply a bead of UHU Por along the trailing

Run the end of a small paint brush along

edge of wing and the elevons

the groove to get a "U" shape fillet of glue

Lay the rear part of the main wing down on the cling film and push the elevons up to the

trailing edge of the wing ensuring the equal spacing of the elevons along the wing.

Weight and pin the elevon to the wing and

Leave a 2-3mm gap at the wing tip

allow to dry for 20 minutes

Do not make the elevons flush to the end of the wings as this will interfere with the

movement of the elevons against the side fins. Pin and weight them to hold them in place.

Allow to dry for 20 minutes. Remove from board, remove cling film and spread out any

excess glue (on the side that was next to the cling film) and allow to dry for a further 20

minutes.

One Half of Motor Mounts

While the elevon to wing joint is drying apply a generous covering of glue to the bottom of

the motor mount, gently move parts in a circular motion to ensure glue covers all parts.

Then immediately separate and allow glue to cure for 12 minutes before carefully aligning

and squeezing together (contact glue style). Repeat the same for the second motor mount

making sure everything is square, as per photo below.

4-Max can not responsible for any damage or injury caused by this flying model.