DuraVent PolyPro Series Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kipas angin DuraVent PolyPro Series. DuraVent PolyPro Series 20 halaman. Polypro single-wall and concentric gas vent system for category ii & iv gas-burning appliances

Halaman Cetak

IMPORTANT

To prevent possible recirculation of flue

gases, the installer must consider the

effects of prevailing wind conditions, eddy

zones, nearby buildings, obstructions,

or other obstacles such as shrubs when

planning exhaust and air intake locations.

DuraVent can not be held responsible for

poor appliance performance or damage to

buildings due to an incorrect installation.

The minimum clearances detailed within

our instructions may not be adequate in

some circumstances depending on the

specifics of the installation. For this reason

we always recommend vertical venting.

SIPHON

2" Equivalent

Length

1-ft Vent Pipe

1-ft

1-ft Flex Pipe

2-ft

(same diameter

as rigid)

1-ft Flex Pipe

0.4-ft

(up-sized one

diameter)

45 Elbow

3-ft

90 Elbow

5-ft

Tee

9-ft

P-TRAP

Figure 1

Table 2 - Equivalent Length Chart

3" Equivalent

Length

1-ft

2-ft

0.6-ft

3-ft

7-ft

12-ft

WARNING

CARBON MONOXIDE POISONING HAZARD

Failure to follow these installation

instructions could result in personal

Refer to the appliance manufacturer's

instructions for maximum and minimum

vent lengths permitted with your specific

appliance model. This information should

include guidance on the maximum number

of elbows and related pressure-drops. The

total vent length from the appliance to

the termination shall not be greater than

specified by the appliance manufacturer.

If specific guidance is not offered by the

appliance manufacturer as to Equivalent

Vent Lengths (EVL) for vent components, the

general guidelines in Table 2 can be used.

CONDENSATE DRAIN (Fig.1)

Refer to the appliance manufacturer's

installation instructions for requirements of

condensate drainage. Ensure proper system

slope for drainage. (Fig.7 and 20)

When using a P-Trap style drain, connect

1-1/4in (32mm) tubing and secure into a

loop. Fill the loop partially with water to

prevent exhaust leakage. Route the free end

of the loop to an appropriate disposal.

4" Equivalent

5" Equivalent

Length

1-ft

2-ft

0.6-ft

N/A

5-ft

6-ft

12-ft

14-ft

19-ft

21-ft

injury or death.

6" Equivalent

Length

1-ft

N/A

6-ft

14-ft

22-ft

8" Equivalent

Length

1-ft

N/A

13-ft

19-ft

29-ft