APlusLift HW-10KOH Panduan Pemasangan & Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Sistem Pengangkatan APlusLift HW-10KOH. APlusLift HW-10KOH 20 halaman. 2-post over head car lift 10,000lb capacity
Juga untuk APlusLift HW-10KOH: Panduan Instalasi & Petunjuk Pengoperasian (17 halaman)
Halaman Cetak
Step 1 (Preparation)
Please carefully remove all the parts from the package.
◦ Remove any loose cables, hoses, part boxes, hydraulic power unit, etc. if they are
inside the columns or banded to the columns.
◦ Remove the power unit box and four swing arms.
◦ Remove the bolts holding the two columns together. Remove top and bottom
columns out of the skid and discard the steel rack.
◦ Remove two column extensions from two columns.
Compare the parts with the part list (at the end of the manual) and contact us if there
are any parts missing.
Please read the installation requirements and anchoring tips in previous pages for
concrete requirement, layout, and drill holes for anchor bolts. The area where the lift
will be installed should be free of overhead obstructions such as heater, building
support, or electrical lines.
Once a location is determined, use a carpenter's chalk line to layout a grid for the
column locations
After the post locations are marked, use a chalk to make an outline of the posts on the
floor at each location using the post base plates as a template.
Double check all dimensions and make sure that the layout is perfectly square.
Installation Instructions
6