4CR 6.3800.1025 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Listrik 4CR 6.3800.1025. 4CR 6.3800.1025 10 halaman. Pneumatic palm random orbital sander

Halaman Cetak

PNEUMATIC PALM RANDOM-

ORBITAL SANDER

6.3800.1005 / 6.3800.1025

BEFORE STARTING THE TOOL

Ensure that:

- the speed control (10) is in MAX position;

- the compressed air feed line and connection are in perfect working order;

- the start lever is working properly. This must be done with the air supply switched off;

- all the components of the tool are mounted correctly and do not show any signs of damage;

- the tool must be connected to a suitable and efficient aspiration device (mobile suction unit or dust bag).

STARTING AND STOPPING

- Starting: push the control lever (2) forward towards the body of the tool and keep it pressed.

- Stopping: release the control lever.

TEST RUN

Start the tool and check that there are no unusual vibrations, no mismatching of the abrasive paper disc. Otherwise switch-off

the tool immediately and eliminate the cause.

SELECTING THE RPM

The RPM can be adjusted by using the speed control (10) from MAX to MIN. The choice of speed depends on the

characteristics of the abrasive paper disc and the material to be worked.

REPLACING THE ABRASIVE PAPER DISCS

- Used discs can be removed by simply tearing them off;

- New Velcro discs are mounted by simply pressing them into the backing pad, making sure that the holes cut in the disc

coincide with those in the backing pad.

USABLE DISCS

Ø150 mm Velcro backed abrasive paper discs with dust extraction holes.

MAINTENANCE

All maintenance operations are carried out with the tool disconnected from the compressed air supply.

At the end of each work session, or when required, remove any dust from the body of the tool using a jet of compressed air.

Lubricate the machine regularly (every 50 hours of operation) by inserting 2-3 drops of specific oil (synthetic oil without

silicone, ISO 32) into the compressed air connection, keeping the device in a vertical position, with the connection facing

upwards. After this operation, connect the machine to the air supply and set it in motion for a few seconds. Lubricate the

machine as described above before storing it for long periods of inactivity. All damages deriving from incorrect or inadequate

lubrication are excluded from the warranty.

No other maintenance operations must be undertaken by the user.

Maintenance and cleaning of the inner parts, must be carried out only by an authorized customer-service workshop.