APlusLift HW-10KOH Panduan Pemasangan & Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Mengangkat kolom APlusLift HW-10KOH. APlusLift HW-10KOH 20 halaman. 2-post over head car lift 10,000lb capacity
Juga untuk APlusLift HW-10KOH: Panduan Instalasi & Petunjuk Pengoperasian (17 halaman)
Halaman Cetak
Step 6 (Installing Swing Arms)
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over
the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for
the three other arms.
Step 7 (Electrical Connection to Power Unit)
the wiring must comply with local code. Find a certified
Warning:
electrician to connect the power unit to a power outlet. Protect each circuit
with a time delay fuse or circuit breaker.
The car lift uses a 220V single phase power unit. The running amperage is 10A.
Recommend a 30A breaker and a 10-gauge wire.
Yellow/Green is ground wire.
For 220V single split phase with two hot wires, wire blue to Hot 1 and wire brown to
Hot 2.
For 220V power from one hot and one neutral, wire blue to neutral and brown to hot.
See the figure below for the reference.
10