Addonics Technologies AESN4DA25-N Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem susunan disk Addonics Technologies AESN4DA25-N. Addonics Technologies AESN4DA25-N 4 halaman. 2.5” snap-in disk array

Halaman Cetak

Front View

Rear View

Installing the Snap-In Disk Array

Step 1. Slide the 2.5" Snap-In Disk Array into a standard 5.25" drive bays

on your system or storage chassis.

Step 2. Secure the Snap-In Disk Array to the drive bay on both sides

with the screws that come with the unit. Note: using other long screws

may interfere with the hard drive installation.

Step 3. Using the included Y power cable, connect the two female SATA

power connectors and 4-pin LED connectors to two ports on the rear of

the unit. Repeat the process for the other two ports.

Step 4. Connect the 4 SATA data connectors to the SATA ports on the

motherboard or SATA controller inside your system.

Step 5. Power on your system. Check to make sure the main power LED

is lit and that the two cooling fans are spinning.

www.addonics.com

Unpacking and Overview

Technical Support (M-F 8:30am - 6:00pm PST)

1. 2.5" Snap-In Disk Array fits into

standard 5.25" drive bay

2. LEDs for drive activity

3. Key lock to lock drive door

4. 4x Snap-In removable drive bays

allow insertion/removal of 2.5"

SATA drive without requiring any

screws

4x SATA data and power

connections

Phone: 408-453-6212

Email: www.addonics.com/support/query/