Addonics Technologies S4SHU3 Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem susunan disk Addonics Technologies S4SHU3. Addonics Technologies S4SHU3 11 halaman. Sapphire snap-in disk array with esata & usb 3.0
Halaman Cetak1. Install drives as described in the Disk Installation section.
2. Connect the AC power adapter's input to a wall outlet and the output
cable to the power connector.
3. Connect either the USB 3.0 or eSATA cable from the Sapphire Snap-In
Disk Array to the computer.
4. Configure the Port Multilpier as described in the Port Multiplier section.
5. Turn on the unit using the power switch on the back next to the power
connector (see note).
1. Be sure the lock on each drive door is unlocked. If not, use the key
that came with the Z Snap-In Disk Array to unlock the drive door. Pull on
the door lever to swing open the drive door all the way.
2. Slide a 2.5" SATA hard drive into the drive slot with the drive connector
side facing in and the label side up. The drive should slide all the way
into the slot with very little resistance. Forcing the drive into the slot will
cause permanent damage to the drive or the Snap-In enclosure.
3. Once the drive is all the way into the drive slot, close the door all the
way till the drive door latches securely. This will engage power and data
connection with the hard drive. You may lock the drive door with the key.
4. To remove the hard drive from the enclosure, simply follow the step 2
– 3 in reverse.
Note:
Hot swapping the drives must be supported by the host adapter. Powering the
cabinet on or off or inserting or removing drives when connected to a host adapter that
does not support hot swapping will cause undesirable results.
Port Multiplier Compatibility
When configured as a set of individual drives and connected to a SATA
or an eSATA host adapter, the Port Multiplier will only work with a Port
Multiplier aware host. This includes setting up the unit with more than
one array. Identify your host controller and check with its hardware
manufacturer if you are unsure. Addonics offers several Port Multiplier
aware host adapters.
Using identical drives for all settings other than JBOD or LARGE is
strongly recommended. Creating a LARGE array using drives that have
different properties will use all space on all members, and performance
will match that of the member in use during any particular I/O operation.
Creating a RAID using drives that are not all the same size will result in
all members using only as much space as the smallest member. Creat-
ing a RAID using drives that have different performance will degrade the
overall performance of the array.
www.addonics.com
Installation
Disk Installation
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/