Addonics Technologies S4SHU3 Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem susunan disk Addonics Technologies S4SHU3. Addonics Technologies S4SHU3 11 halaman. Sapphire snap-in disk array with esata & usb 3.0
Halaman CetakMac and Linux users may download those versions of the same utility
from http://addonics.com/drivers/driver_list.php under "Port Multiplier &
Hub." The JMicron RAID Manager can be used to create, modify, and
monitor the health status of the RAID drives, and provide status alerts
with dialog boxes and even email. When configuring the RAID mode
using the RAID Manager application, it is strongly recommended to leave
the dip switch in the factory default setting.
Setting or Modifying the RAID Mode
This procedure briefly describes the steps for using the Jmicron RAID
Manager's Basic Mode to create an array. The example shown is a
LARGE set. There are other options available in the Advanced Modes,
including building arrays using specified drives, setting up email notifica-
tions, and updating the firmware – which are not discussed in this user
guide.
After starting the Jmicron RAID Manager, the first screen will show the
status of any Port Multipliers detected and any drives connected. Shown
below is a Port Multiplier with a variety of five drives connected:
On the left pane is "Controller 1" which is the first port multiplier detected
by the software. Shown in a tree view are the five drives, listed as P0-P4.
These are currently individual drives. On the right pane is a listing of the
drives and below that is a graphical view of each drive. "Disk 1" through
"Disk 4" indicate which physical port the drive is connected to. For the
AD5HPMSXA, AD5HPMRXA-E, and AD5HPMREU this refers to ports
P0-P4. On the CPR5SA unit, this refers to HD0-HD4. On the
AD5EHPMEU3 this refers to D1-D5. On RAID Tower products this
relates to the drives mounted left to right or top to bottom, except in
cases where a drive map is included showing otherwise.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/