Apogee AD-8000 Catatan Aplikasi

Jelajahi secara online atau unduh pdf Catatan Aplikasi untuk Konverter Media Apogee AD-8000. Apogee AD-8000 1 halaman. When i feed the ad-8000 a 20- or 24-bit signal from some of my gear, the 16/20/24 resolution indicators do not read the correct word length (number of bits). why is this?
Juga untuk Apogee AD-8000: Lembar data (1 halaman), Catatan Aplikasi (2 halaman), Catatan Aplikasi (2 halaman)

Halaman Cetak

Application Notes

Product: AD-8000/DAC-8 Analog Output Card

Topic: 16/20/24 Bit Indicators

Document #: 5

Question/Issue:

When I feed the AD-8000 a 20- or 24-bit signal from some of my gear, the 16/20/24 resolution

indicators do not read the correct word length (number of bits). Why is this?

Answer:

The 16-/20-/24-bit indicator section displays the setting of the word-length status bit of the

incoming digital signal selected in SOURCE SELECT. The AD-8000 does not "count" the

number of bits in an incoming digital signal. As of this writing, many audio manufacturers have

not adopted the use of this status bit. Therefore, even though you may be playing back a 24 bit

signal from your DAW, for example, the AD-8000 may still indicate "16" bit resolution. Don't

worry, if you recorded the material at 24 bit, it's coming back at 24-bit resolution into the AD-

8000 (unless you've done something tricky to it in the interim or have applied UV22).

As of this writing, it is suggested that the truncation logic DIP switch (AUX Control DIP SW #9)

be set to "ON" (so that the truncation logic is disabled) when feeding the AD-8000 a 20 or 24 bit

digital signal. In this case, if an incoming 24 bit signal incorrectly identifies itself as a 16 bit signal

(or doesn't identify itself at all), the AD-8000 will not truncate the least significant bits. Again,

please note that to disable truncation logic, DIP SW #9 is set to "ON" which is the UP position. See

page 19 of the manual for more information.

Apogee Electronics Corporation

16/20/24 Bit Indicators

Page 1 of 1