Apogee 00524 Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Mainan Apogee 00524. Apogee 00524 10 halaman. Fin shape science experiment kit
24. Fold the parachute and insert it into
the rocket along with the shock cord. Tem-
porarily place one of the assembled fin-cans
over the engine mount and exposed end of
the tube coupler. DO NOT GLUE!
25. Roll a piece of paper and insert it
into the back of the rocket to hold the model
while you paint it. Similarly, roll a sheet of
paper and insert it into the back of each fin
can so you hold them while you paint them.
For best results, paint the model with primer
before using the final paint colors. Follow the
directions on the paint can, and always paint
outdoors with the wind against your back.
Let the paint harden at least 24 hours before
proceeding. You may paint the model your
favorite color.
Allow the paint time to dry and install the
sticker decals as desired.
26. Remove the display stand parts from
the laser-cut sheet. Glue them together
using wood glue as shown. Allow the glue
time to dry. You can place your rocket on the
display stand for everyone to gaze at when
you are not launching it.
Congratulations! Your Fin Shape Science
Experiment rocket is now complete.
Launch Supplies Needed
To launch your rocket you will need the
following supplies:
• A model rocket launching system
• Flame resistant recovery wadding
• Altimeter to measure the height of the
rocket
• Data sheet to record the results of your
project.
• Recommended Rocket Engines: B6-4,
or C6-5
Rocket Preflight
A. Tie a string from the altimeter (NOT
INCLUDED) to the loop on the nose cone.
This is recommended in case the nose
comes off during flight. Remember to turn
on the altimeter and make sure it is ready to
launch.
B. Wrap a single layer of tape each
around the perimeter of the rocket over both
the nose cone joint, and the fin can joint.
This is what holds them on during flight, and
allows the fin cans can be swapped between
launches.
Page 6
NO Glue
24
25
26
A
Joint
B
Joint
Tape
Tape