Apogee Apprentice 5039 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Mainan Apogee Apprentice 5039. Apogee Apprentice 5039 6 halaman.

6. Apply a bead of wood glue around the

front of the motor mount tube that extends

out of the front of the plastic fin unit. Slide the

remaining green centering ring over the tube

so that it rests against the front shoulder of the

plastic fin unit.

7. Draw a pencil line down the length of the

long body tube using a door jam or aluminum

angle. Mark the tube 1-1/2" (3.8 cm) from one

end. Apply glue along one side of the launch

lug and attach it to the body tube, aligning the

back end with the mark just made. Make sure

the launch lug is parallel with the body tube as

shown. Let the glue dry. Then apply a fillet of

glue to both sides of the launch lug for extra

strength. Allow this to dry too before proceed-

ing.

8. Apply wood glue inside the rear end of

the body tube (the end closest to the launch

lug). Slide the plastic fin unit into the body

tube until it stops against the shoulder of the

fin unit. Be sure the launch lug is centered

between two of the fins.

9. Cut out the paper shock cord anchor

from page 1. Smear wood glue over one

surface. Lay the yellow Kevlar

a diagonal along the paper shock cord anchor.

Fold as shown in the illustration. While the

glue is still wet, curl the edges upward so that

it will conform to the inside of the body tube.

Allow the glue time to dry.

Sheet B - P/N 31079

shock cord at

1-1/2" (3.8 cm)

Page