Apogee Midge Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mainan Apogee Midge. Apogee Midge 8 halaman. A two-stage payload altitude rocket

24. Place one reinforcement ring on each
of the corners of the parachute canopy.
Take a sharp pencil or knife and poke a hole
through the plastic in the center of each ring.
25. Cut the shroud lines to make a total
of three lines of equal length. Then pull each
parachute line end through a parachute re-
inforcement ring and tie using two overhand
knots. Repeat for all the corners as shown.
26. Holding the parachute at the center of
its top, pull the lines together to even up the
ends. Thread the three looped lines through
the loop in the shock cord. Next, take the top
of the parachute and pull it through all three
string loops at the same time. Finally, pull on
the strings to tighten the knot. This securely
attaches the parachute to the rocket.
27. Fold the parachute and insert it into
the rocket along with the shock cord.
28.Temporarily assemble the rocket. You
can use the red tube coupler to join the two
stages together. Roll a piece of paper and
insert it into the back of the rocket to hold
the model while you paint it. We recommend
a fluorescent color like orange, pink or yel-
low to make it easier to find the rocket after
touchdown. Allow the paint time to dry.
Congratulations! Your Midge rocket is
now complete.
Launch Supplies Needed
To launch your rocket you will need the
following supplies:
• A model rocket launching system
• Flame resistant recovery wadding
• Recommended Rocket Engines:
See the motor matrix to the right.
Page 6
24
25
26
27
red coupler
28
Midge Rocket Recommended Motors
Engine
Manufacturer
A10-3T
A10-0T / A3-4T
A10-0T / A10-3T
Altitude (ft)
Estes
259
Estes
671
Estes
637
Altitude (m)
79
204
194