APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER Panduan Pemilik dan Petunjuk Penyiapan - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pemilik dan Petunjuk Penyiapan untuk Crossover APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER. APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER 9 halaman.
Halaman CetakAPOGEE ACOUSTICS INC.
ACTIVE CROSSOVER
INTRODUCTION
The Apogee Acoustics, Inc active crossovers is designed to provide electrical
separation of woofer and midrange/ tweeter signals for bi-amped or tri-amped
systems. This is accomplished at the signal level between the pre-amplifier and
power amplifiers in a manner to provide the most coherent and musically accurate
result. The active crossover approach provides a high impedance to the pre-amp
drive and low source impedance to drive the power amplifiers. The audio system with
the active crossover consequently provides excellent resolution and overall
performance plus the convenience readily working with a brand range of amplifiers
ADJUSTMENTS AND USE
The active crossover is set at the for factory for proper operation with the
following Apogee speakers, large Full Range, Scintilla and the Duetta Series II.
The active crossover may be operated as a two-way or a tree-way crossover when used
with the Full Range Apogee's. The active crossover or may be operated as a two-way
crossover for use with the Scintilla and Duetta Series II.
Be certain that you are utilising the active crossover that is designed for use
with the correct Apogee speaker model. Each speaker model requires a different
active crossover network. You may select either and active crossover that is
compatible with both the Full Range Apogee and the Scintilla or an active crossover
that is compatible with the Duetta Series II.
The control pots on the front of the crossover, when used in the dedicated bi-amped
configuration, provide for attenuation of the woofer and midrange/tweeter channels.
The attenuation has a resolution of approximately 1/4 dB with an infinite range.
The active control pots are the left and right channel woofer and the tweeter pots.
The midrange pot is inoperative in a bi-amped configuration.
The frequency response slope at the crossover frequency is 6bB per octave. The
slope well beyond the crossover frequency is increased to provide greater
separation between the woofer and midrange transducers.
IMPEDANCE
The crossover input, impedance is river 100K ohms and the output impedance loss
than 1K ohms. These impedance levels will function properly with most modern pre
and power amps.
(Page 1)