4D systems gen4-uLCD-50 D Panduan Memulai Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Unit Kontrol 4D systems gen4-uLCD-50 D. 4D systems gen4-uLCD-50 D 6 halaman. 5.0” slim intelligent display module with embedded diablo16 processor and resistive or capacitive touch panel
Halaman CetakQUICK START GUIDE
Power Up and Connect to a Computer Using gen4-PA
1) Connect one end of the FFC to your module's 30-way ZIF socket with the metal
contacts on the FFC facing up on the latch.
2) Connect the other end of the FFC to the 30-way ZIF socket on the gen4-PA* with the
metal contacts on the FFC facing up on the latch.
3) Connect the USB-Micro-B Cable to the gen4-PA.
4) Lastly, connect the other end of the USB-Micro-B Cable to the computer.
Power Up and Connect to a Computer Using 4D-UPA
1) Connect one end of the FFC to your module's 30-way ZIF socket with the metal
contacts on the FFC facing up on the latch.
2) Connect the other end of the FFC to the 30-way ZIF socket on the 4D-UPA* with the
metal contacts on the FFC facing up on the latch.
3) Connect the USB-Micro-B Cable to the 4D-UPA.
4) Lastly, connect the other end of the USB-Micro-B Cable to the computer.
*NOTE: It is strongly recommended that you keep the gen4-IB, gen4-PA or 4D-UPA
connected to the FFC and the display module throughout your project development
phase due to potential wear on the FFC connector. These connectors are not
designed for hundreds of connect/disconnect cycles.
Page 4 of 6