Apollo Spas Explorer Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Bak Mandi Air Panas Apollo Spas Explorer. Apollo Spas Explorer 20 halaman.

Start-Up Instructions

Once the spa is placed on a solid foundation and supplied with power, the spa should be filled and prepared for

use. For the best results, read each step completely before proceeding with the following steps.

1. Prepare the spa for filling.

Clear all the debris from the inside of the tub.

Wipe off and clean the acrylic with a wet towel to remove dust.

Remove the service door and tighten all the hand unions at the pump(s) and heater.

Ensure all the knife valves are in the open (UP) position.

2. Fill the spa.

A. Front Access Skim Filter (Rainier, Columbia, Chelan, Cascade)

Fill the spa through the opening until the water submerges all of the jets excluding the neck jets and

1/2 way up the opening of the weir gate. DO NOT let the water go below 1/2 of the way up the weir

gate assembly.

B. Pressure Filter Canister Assembly (Explorer, Triton, Gemini)

Locate the filter canister. Remove the lock ring and the filter lid. Remove

the filter element. Insert the garden hose into the filter canister and begin

to fill the spa. Once the water has filled the foot-well, add Stain & Scale

Defense (refer to the directions on the product label). Insert the hose into

the foot-well and continue to fill until the water is 1" above the wall jets

(excluding the neck jets) or covering 2/3 of the skimmer. Reinstall

the filter, lid and lock ring. The lock ring should spin and then lock into place.

Fill the tub with the garden hose until all jets excluding the neck jets are submerged.

C. Telescoping Filter Bucket (Discover, Saturn, Commander)

Using a garden hose with a pre-filter, fill the spa with pre-filtered water to the bottom of the pillows