Apollo Sprayers MAXI-MISER PBC7600-GTO Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penyemprot Cat Apollo Sprayers MAXI-MISER PBC7600-GTO. Apollo Sprayers MAXI-MISER PBC7600-GTO 20 halaman.

Halaman Cetak

5. Setup

5.1

Installing Air Relief Mechanism (Turbine Systems Only)

As previously noted, Apollo Models 725, 825, 835, 835VR, 1025, 1035,

1040VR,1050, 1050VR, Falcon Series, Power Series and Precision Series have

an air relief mechanism internally installed and DO NOT require an external air

relief mechanism. All other Apollo Models require the installation of Apollo

Part # A7538A to the turbine air outlet prior to operating the 7600 spray gun

The air relief mechanism Part #A7538A must also be installed on ANY MAKE

turbine system that does not have an air relief mechanism installed. If using with

a system other than Apollo, please check with the manufacturer to determine if

a non-bleed spray gun can be safely operated on your system. If not, install

Part #A7538A before operating the 7600 spray gun.

5.2

Mounting Your PBC7600-GTO Spray Gun Cup

Good quality results with your spray finishing equipment are a combination of careful

preparation of your surface, a proper spraying environment and a basic knowledge of the

coatings you will be using and how these coatings work with your finishing equipment.

Your PBC7600-GTO spray gun comes with one of 4 sizes gravity feed cup assemblies,

90cc, 250cc, 600cc or 1000cc. Some minor assembly is required:

1. Screw the cup to the material connector on the top of the spray gun body.

3. Screw the air feed connector onto the side of the spray gun body.

2. Remove the screw in the side of the spray

gun body using the wrench (spanner) provided.

4. Push the air feed tube onto the air feed connector.