Apollo Sprayers T6000 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Produk Perawatan Pribadi Apollo Sprayers T6000. Apollo Sprayers T6000 11 halaman. Mist applicator

Halaman Cetak

Prepare the T6000 Mist applicator

1. Follow the diagram to prepare the Mist applicator

a. Unscrew the plastic cup from the Mist applicator. Pour tanning solution into the cup. Do not fill more than ¾

full.

b. Carefully screw the cup back onto the main body of the Mist applicator. Screw the cup on firmly but DO NOT

over tighten. Over tightening will cause the cup to "pop" and damage the threads. Leakage can

then occur requiring replacement of the cup.

c. Locate the air cap (#2) on the T6000 diagram. Slightly turn the air cap ring (#1) anti or counter clockwise

to loosen the air cap. Notice that you can now rotate the air cap freely.

d. Look at Mist Applicator Patterns diagram below. Note the position of the air cap and the direction of the

spray pattern. Pattern 1 is for spraying across from side to side. Pattern 2 is for spraying up and down.

Pattern 3 will produce a spot or circle. Patterns 1 and 2 are the most common positions for applying

tanning solutions.

e. Turn the air cap (#2) to the position you want. Turn the air cap ring (#1) clockwise to lock the air cap in

place.

MIST APPLICATOR

1. Next, position the T100 Turbo Unit as far away as

practical and possible from the area where you will

spray.

2. Attach the remaining end of the hose to the T6000

Mist applicator as follows:

a. Locate the coupler at the rear top of the T6000

Mist applicator. See T6000 diagram.

b. Pull back on the collar of the black connector on

the air hose.

c. Push the connector over the coupler and release.

Figure 7.

d. Your Mist applicator should now be firmly attached to the air hose.

1. Misting across from side to side

2. Misting up and down.

3. Misting in a spot or circle

PATTERNS