Dashmate DSH-680 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Dasbor Dashmate DSH-680. Dashmate DSH-680 12 halaman. Discreet 1080p dash camera with gps, wifi & super capacitor

Halaman Cetak

2.4 INSTALLING YOUR DSH-680 WINDSHIELD BRACKET.

1. To install the Windscreen Bracket, clean your windscreen with an Alcohol Wipe

making sure there is no dust, moisture, or oil on the desired mounting point of the

windscreen. This is very important for correct adhesion.

Remove the protective film on the adhesive pad and with the open side of

the slot facing the driver's side. Place the Windscreen Bracket in your desired

placement, ensuring that the open side of the mount is facing the driver's side

of the vehicle, and allowing at least 4cm between the top of the bracket and the

top of your windscreen.

Firmly press and hold the windscreen bracket against your windscreen for 60

seconds to ensure that the adhesive sets.

Once the adhesive has set (allow 5 minutes), slide the barrel camera into the slot

by sliding the camera from right to left direction until it stops.

____________________________________________________________________________________________________________

NOTE:

• It is recommended that the DSH-680 is mounted behind your rear view mirror so that it is not

obstructing the drivers view.

• Once installed it is not recommended that the Windshield Bracket is removed as it is not possible to

re-install once it has been removed.

____________________________________________________________________________________________________________

2.5 INSTALLING YOUR GPS RECEIVER

Using your preferred method, it is recommended

that you run the power cable around your windscreen

under your vehicles interior trim toward the driver's

side. The 12V power cable is supplied with an in-

line GPS receiver that must be mounted onto the

windscreen with the supplied adhesive.

For best GPS reception, the GPS module should be placed as far away as possible

from the barrel camera.

____________________________________________________________________________________________________________

NOTE:

• It is advised that you run the cable beneath head liner trim and under the dash ensuring that the

cable does not interfere with the operation of your vehicle.

____________________________________________________________________________________________________________

2.6 CONNECTING POWER TO YOUR DSH-680

DSH-680

Your

power from your vehicles electrical system via the 12V cigarette

or accessory port for continuous operation. Your DSH-680 does

not have an internal battery and will turn off when disconnected

from its power source.

Your unit is supplied with a dual USB output 12VDC charger that

will supply power to your unit, and offers a spare USB output to

connect to other USB powered devices such as a mobile phone.

To connect power to your DSH-680, plug the Dual Socket USB

Car Charger into your vehicles accessory power socket (cigarette

lighter port), and then connect the USB end of the supplied cable

to the USB port labelled 2.4A (The spare 1A socket can be used to

charge any of your 1A USB devices capable of taking a 1A charge).

Connect the USB micro end of the cable into your DSH-680 Barrel

camera.

2.7 REMOVING THE DSH-680 FROM THE WINDSHIELD MOUNT

To remove your DSH-680 from your car, simply slide the unit

horizontally from left to right.

2.8 POWERING UP THE DSH-680

The DSH-680 will power up and begin recording automatically once it has been

correctly installed (micro SD card must be installed), and you start your vehicle.

A blinking RED LED (after approx. 30 seconds from start-up) indicates

recording.

There are no buttons to press on the device so recording will only stop when the

vehicle is turned off or if the micro USB cable is disconnected from the unit.

____________________________________________________________________________________________________________

NOTE:

• Recording will stop whilst playing back footage from your DSH-680 to your app.

____________________________________________________________________________________________________________

must be connected to a constant supply of