Aponorm Basis Control Petunjuk Penggunaan Manual - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Monitor Tekanan Darah Aponorm Basis Control. Aponorm Basis Control 19 halaman.

Halaman Cetak

6. Press the ON/OFF button

rement.

7. The cuff will now pump up automatically. Relax,

do not move and do not tense your arm muscles

until the measurement result is displayed.

Breathe normally and do not talk.

8. When the correct pressure is reached, the

pumping stops and the pressure falls gradually.

If the required pressure was not reached, the

device will automatically pump some more air

into the cuff.

9. During the measurement, the pulse indicator

flashes in the display.

10. The result, comprising the systolic

diastolic

blood pressure and the pulse rate

is displayed.

11. When the device has finished measuring, re-

move the cuff.

12. Switch off the device. (The monitor does switch

off automatically after approx. 1 min.).

How not to store a reading

Press the ON/OFF button

being displayed. Keep the button pressed until

«M»

is flashing and then release it. Confirm by

pressing the M button again.

aponorm

Basis Control

to start the measu-

and the

while the reading is



You can stop the measurement at any time by

pressing the ON/OFF button (e.g. if you feel

uneasy or an unpleasant pressure sensation).

4. Appearance of the Pulse Arrhyth-

mia Indicator for early Detection

This symbol

indicates that certain pulse irregu-

larities were detected during the measurement. In

this case, the result may deviate from your normal

blood pressure – repeat the measurement.

In most cases, this is no cause for concern. Howe-

ver, if the symbol appears on a regular basis (e.g.

several times a week with measurements taken

daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

Information for the doctor on frequent appea-

rance of the Arrhythmia indicator

This device is an oscillometric blood pressure

monitor that also analyses pulse irregularity during

measurement. The device is clinically tested.

The arrhythmia symbol is displayed after the mea-

surement, if pulse irregularities occur during mea-

surement. If the symbol appears more frequently

(e.g. several times per week on measurements

performed daily) we recommend the patient to

seek medical advice. This device does not replace

a cardiac examination, but serves to detect pulse

irregularities at an early stage.