Düren tools 321275 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sander Düren tools 321275. Düren tools 321275 7 halaman. Air operated 10mm belt sander

Halaman Cetak

PLEASE KEEP THIS MANUAL SAFE FOR FUTURE REFERENCE

It is strongly advised that you always use a Whip Hose/Leader Hose in combination with

Quick Release Couplings. See Fig. 2 for recommended setup.

PLEASE KEEP THIS MANUAL SAFE FOR FUTURE REFERENCE

Water in the air supply will cause the internal bearing of the tool to rust and eventually

seize.

Make sure that your airline is free from water at all times.

Always select the correct sanding disc grit for the job.

Warranty

Tools Included with your Sander

We hope that you will be very happy with your purchase. If you do have a problem with your tool,

you have the added peace of mind of a 12 month warranty, which comes into date from the date of

purchase (proof of purchase required).

Scope of Warranty

- The warranty will cover you from all faults caused by defective components or poor workmanship.

- Tools sent outside the EU are not covered by this warranty.

- Product must be returned to us, the warranty does not cover cost of carriage.

1 x High Flow Male Air Fitting

- If the product is no longer in manufacture, it will be replaced with a tool of equivalent or higher

specification.

Maintenance

What is not covered

If the air supply is not lubricated sufficiently it will be necessary to lubricate the tool

- Normal wear and tear caused by use in accordance with the operating instructions.

directly. This can be done by disconnecting the air hose and pouring in 5ml of air tool oil

- Replacement of any provided accessories, such as Backing Pads, Airline Connections, Air

into the Air Inlet. Read safety data sheet or instructions on use of oil to ensure safe

Fittings, Blades, Spanners, etc.

usage. These can be obtained from your supplier.

- Accidental damage, faults caused by negligent use or care, neglect, misuse or careless operation,

Replace worn or damaged parts using genuine parts only.

handling and storage of the product.

Store tool in a dry area, do not allow tool to be immerse in water or used/stored in wet

- Modification of, or change of, any part of this product in any way.

conditions.

- Faults caused by use of non compatible accessories.

- Tool seizure caused by insufficient oiling.

- Faults caused by incorrect installation.

- Repairs or alterations carried out by non-approved parties.

- Traces of water or rust inside tool - this shows that a properly working air filter has not been used.

Validity

- This warranty is valid for 12 months after date of purchase.

- Warranty is rendered invalid if;

- Tool is taken apart for any reason without our consent.

- Tool is not oiled daily.

- Air supply line is not used with a properly working air filter.

- A warranty claim will not be accepted without an official proof of purchase from your supplier.

Duren Tools

T: 01582 484875 E: [email protected]