4EVAC 4E-FMTC Instalasi dan Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Mikrofon 4EVAC 4E-FMTC. 4EVAC 4E-FMTC 17 halaman.
Halaman Cetak
Hacousto Holland bv
Industrieweg 87
2651BC Berkel & Rodenrijs
4E-FMTC installation and user guide
Device ID
The microphone station needs an ID setting in order to be properly recognized in the network and operate.
If the device ID is duplicated or set to a wrong value, the device will not receive the correct configuration
settings from the main unit. In this case the remote station will be stuck in a boot sequence and remain
non-operational.
The device ID is set by means of two rotary switches, which define the two-digit hexadecimal value of the
ID.
In order to check or set the Device ID, you must access the rotary switches on the back side of the unit:
1.
Remove the steel plate covering back of the station
2.
Identify the high-significant and low-significant rotary switches. The Device ID is a combination [HI
LO] of those two digits.
3.
Make sure the ID value exists in your configuration settings, relates to the right device type and is
not duplicated to another device. Allowed values: 01-FE
4. Set the Device ID value according to the configuration settings of the Compact 500 system.
5.
Plug-in the L-Net cable connecting the station with the C500 main unit.
6.
Observe the boot sequence and afterwards the unit automatically entering normal operating
condition.
7.
Assemble the back plate (and optionally the rubber feet).
Page 8 of 17
HIGH
LOW
4E-FMTC bottom view: Device ID setting
Author:
DD