Appalachian Stove & Fabricators XLB Panduan Instalasi dan Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Kompor Appalachian Stove & Fabricators XLB. Appalachian Stove & Fabricators XLB 19 halaman. Zero-clearance
Halaman Cetak3. INSTALLING THE GEMINI XLB UNIT (Fireplace
Installation)
Special care should be taken in selecting the site for fireplace
installation of the Gemini XLB unit. A centrally located site
will provide equal heat distribution. The site you select for
installation, and the unfinished construction, will also
enhance the value and overall appearance of your home.
Finishing construction details may be done in wood, brick,
paneling, "cut" or "natural" stone masonry to blend with
your present decor.
(A) After selecting your site, place the Gemini XLB unit in
the desired position.
(B) Attach the chimney to the stove by following the special
instructions on page 8 in the freestanding section.
(C) Finish construction around the unit (FIGURE 5).
(D) Trim the stove unit in desired materials to match your
decor (wood, paneling, brick, "cut" or "natural" stone may
be used).
(E) Install the protective hearth in front of the unit last, after
all other construction is complete.
(F) Do not block any natural cooling vents of the Gemini
XLB fireplace unit when installing.
NOTE: If a raised hearth is used, raise the Gemini XLB unit
in proportion to the elevation to avoid blocking stove vents
and to maintain correct 22" hearth clearance to combustibles.
This completes the installation of your Gemini XLB unit.
Please refer to section VII and VIII for instruction on
operation and stove maintenance.
4. IMPORTANCE OF PROPER DRAFT
Draft is the force which moves air from the appliance up
through the chimney. The amount of draft in your chimney
depends on the length of the chimney, local geography,
nearby obstructions and other factors. Too much draft may
lead to excessive temperatures in the appliance and may
damage the catalytic combustors. Inadequate draft may cause
backpuffing into the room and "plugging" of the chimney
catalyst.
NOTE: Inadequate draft will cause the appliance to leak
smoke into the room through the appliance and chimney
connector joints.
NOTE: An uncontrollable burn or a glowing red stove part
or chimney connector indicates excessive draft.
FIGURE 5
FINISHING THE CONSTRUCTION
FOR FIREPLACE INSULATION
FIGURE 6
INSTALLATION SUGGESTIONS
(Top View)
6