AddSecure Tor V Panduan Instalasi - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pemancar AddSecure Tor V. AddSecure Tor V 20 halaman. Alarm transmitter
Halaman Cetak
8
MAINTENANCE
The alarm transmitter does not require any periodical maintenance.
An order must be placed to change the service or the control of the alarm. Contact AddSecure
for further information about placing orders and making changes to the alarm transmitter.
Local programming is not necessary.
9
TROUBLESHOOTING
9.1
All diodes are blinking at the same time
If the alarm transmitter gets its power from the control panel, check that there is no current
limitation for the control panel. The alarm transmitter can use up to 3A at 24V DC during
startup with a built-in battery backup or 2A at 12V DC without a battery backup.
9.2
The A diode is blinking and the C diode is turned off
The alarm transmitter does not have contact with the mobile network. Check the cables and
the antenna. The cables must not be spliced or pinched. The antenna must not be placed in a
steel cabinet, near fluorescent lamps, or close to other equipment that may interfere.
9.3
Weak signal strength
Check the cables and connect the external antenna. The cables must not be spliced or pinched.
The antenna must not be placed in a steel cabinet, near fluorescent lamps, or close to other
equipment that may interfere.
9.4
No Internet connection
Check that the network cable is in ETH0 and that the cable is a patch cable.
Some models of gigabit switches have had problems with the alarm transmitter. If
needed, mount a 10/100 switch between the gigabit switch and the alarm transmitter
to fix the problem.
AddSecure Tor V, PDK-11606
15