AddSecure IRIS-4 50 Panduan Instalasi dan Pemeliharaan Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemeliharaan Cepat untuk Terminal sentuh AddSecure IRIS-4 50. AddSecure IRIS-4 50 8 halaman.

Halaman Cetak

Connecting power

The power provided to the terminal via the cable

connection should be DC (see specification section)

and battery backed from the alarm panel. Once

power is provided, the terminal will:

• Instigate connection to the cellular network, using

the eSIM already fitted.

• Report status on the LEDs, as described in the

LED Indications table.

Once the cellular connection has been made, as

indicated by the cellular status LED, the cellular

signal strength can be seen by holding down the

default/signal strength button. When the button is

pressed for 4s, all LEDs will go off briefly, and then

re-light, showing the signal strength accordingly:

• Only panel (red) LED on – signal strength lower

than recommended.

• Panel (red) and cellular (yellow) LEDs on – signal

strength acceptable.

• All LEDs on – signal strength high.

Use this to locate the antenna for best signal and

then fix the antenna to this position.

Note: The terminal can be powered from the

USB connection for local configuration but the

cellular interface will not operate unless it is

powered with an appropriate power supply.

6.5 Configuring the terminal

The terminal can be configured using the IRIS

Toolbox software application on a PC connected to

the terminal with a USB cable. Please use Toolbox

software version 4.7.1 or later.

To reset to factory default settings:

• Power down the terminal.

• Hold down the default/signal strength button.

• Power up the terminal.

• Continue to hold the button down for 5s and

then release it.

The LEDs will flash to indicate the default has oc-

curred, as described in the LED Indications table.

6.6 Commissioning test

Once the configuration of the terminal is complete,

perform a full commissioning test in collaboration

with the ARC. This will normally involve testing nor-

mal alarm transmissions from the alarm panel to the

ARC and verifying acknowledgement of these alarms

with the operators at the ARC.

6.7 Maintenance

Inspect the terminal on an annual basis. At each

inspection, perform the following routine:

• Check the terminal mountings are still secure.

• Confirm the current status of the terminal from

the LEDs.

• Clear any faults on the terminal.

• Check if the terminal is running the latest

software.

• Perform full test of alarms from the alarm panel

and confirm acknowledgement of these by the

operators at the ARC.

You can check for current faults, reflash to the latest

software, perform communication path checks and

other tasks using the IRIS Toolbox.