Data Harvest EASYSENSE V-Hub Panduan Referensi - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Referensi untuk Pencatat Data Data Harvest EASYSENSE V-Hub. Data Harvest EASYSENSE V-Hub 15 halaman.
Halaman Cetak
EASYSENSE V-Hub Reference Manual
Select the computer acting as the Controller
from the list of available devices, OK.
The text on the top right of the
EASYSENSE window will
indicate that connection as a
Viewer has been established.
On an iPad that will be acting as a Viewer:
From Settings set Wi-Fi to the same network that the 'Controller' PC is connected to.
(a)
Open the EasySense iPad software, select the 'Not Connected' text at the bottom right of the
(b)
screen and select the 'name' of the computer acting as the Controller from the list of devices.
(c)
The text will change to indicate that connection as a Viewer is established
On an Android that will be acting as a Viewer:
From Settings set Wi-Fi to the same network that the 'Controller' PC is connected to.
(a)
(b)
Open the EasySense Android software, select the Connect icon (top right of screen) and select
the 'name' of the computer acting as the Controller from the list of devices.
(c)
The text bottom right of screen will change to indicate that connection as a Viewer has been
established
Step 7:
The Home screen will open. Select one of the experiment modes e.g. EasyLog, Pictogram, Meters,
Snapshot, Counting or Timing.
Using V-Hub connected via Bluetooth to a computer
If using V-Hub battery powered, fully charge the battery before use e.g. leave to charge overnight for use
in lessons the next day. When the battery is in good condition and fully charged it will power a Bluetooth
connected V-Hub for about 8 hours.
Note: V-Hub stays awake while Bluetooth is turned on. Disconnect after use as the battery will continue to drain if V-
Hub is stored with Bluetooth still selected.
Do NOT pair the devices (when paired V-Hub will not be made available to the EasySense software).
When connecting to a Windows computer
V3.9 or later of the EasySense Windows software must be installed on the computer. An operating
system of Windows 7 or above is required.
Connect a 2070 or 2071 Bluetooth Smart USB adaptor to the USB port on the
Windows computer. The adaptor is a plug and play device whose drivers
should install automatically*.
On V-Hub short press the button until the cursor points
to Bluetooth. Press the button for approximately 3
seconds until the option highlights then release.
The screen will show the name of the logger.
Open the EasySense software on the PC.
Data Harvest Group Ltd, 2017
Bluetooth
►USB
Wi-Fi
About
Bluetooth
Humboldt 15
12
DO260 (2)
to exit