Appion TEZ 8 Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pompa Daya Appion TEZ 8. Appion TEZ 8 14 halaman. Two stage vacuum pump

Standard Setup Continued

Turn the power switch ON.

Note: The TEZ8 is designed with a soft start to prevent unnecessary stress and wear on

the pump. Open the cap on the 1/4" inlet port when starting the vacuum pump to allow it to

start easier. Close the 1/4" port cap tightly once the TEZ8 is running at full speed.

Evacuate the system, following standard servicing procedures.

Shut Down Procedure

Close the manifold valve between the pump and the system.

Slowly remove the hose from the pump inlet to remove any residual oil from the pump.

Turn the power switch OFF.

Keep inlet ports capped when not in use to prevent moisture accumulation inside the pump.

The TEZ8 is equipped with four input fittings of different sizes. These fittings should be kept

sealed with the included Appion MegaSeal

moisture from accumulating inside the pump. For increased flow and shorter evacuation times,

multiple inputs may be used at once.

The input assembly can be swiveled to allow easy

access to the desired ports, depending on hose and

system port availablity.

To change the orientation, loosen the screw collar

under the ports by turning it counterclockwise. You

can then swivel the input fittings to face the desired

direction. Once you have oriented the fittings, tighten

the screw collar by turning it clockwise.

A Remote Exhaust Vent Connection is located on top of the front face of the TEZ8. It is threaded

for connection to a standard garden hose, which can be used to vent exhaust to another location.

To minimize any back pressure on the pump, be sure the hose is free of any obstructions and is

the shortest length needed to reach the desired exhaust location.

The TEZ8 is equipped with a clear Debris Monitor/Catch Tube located in the right-front corner of

the machine which allows you to observe the incoming airflow for debris, oil or any other material

which could damage the pump. Be sure to empty and clean this tube after every job.

Note: Monitor this tube regularly during operation, as liquids present in the tube may raise the

vapor pressure at the pump and drastically increase evacuation times.

caps when the pump is not being used to prevent

Tighten

Loosen