Data Technology 5150XL Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Data Technology 5150XL. Data Technology 5150XL 6 halaman. Disk controller

Halaman Cetak
4.0 Con't
*
Format
Drive no.
Interleave
Utility
(1·2):
(2·9):
*
(Enter the drive number
that you want
to
format).
(Enter the interleave
factor desired. For
optimal system performance
an interleave of 3 is
recommended).
4.0
Con't
g.
Split into 2 logical units?
(YIN)
Enter drive defect table?
(YIN)
Is above information correct?
(YIN)
Ready to ERASE entire disk?
(YIN)
When the format is done, the following
message will appear:
e.
If the W3 jumpers have been manually
a specific drive type, the system will
display the drive configuration that has
selected. Answer the following questions
that will appear below the drive
configuration.
set for
been
Format Complete.
Insert DOS diskette in drive
A:
Proceed to FDISK and FORMAT.
Hit
any key
to reboot the system.
Enter drive defect table?
(YIN)
Is above information correct?
(YIN)
Ready to ERASE entire disk?
(YIN)
h.
If you have more than one hard disk, repeat
the same procedure for the next physical hard
disk.
e.
If all W3 jumpers are removed, a drive table
(See Section 4 1) will appear on the screen.
After you have selected the correct 'drive
type by the table number, the system will
display the drive configuration that has been
selected. Answer the follOWing questions
that will appear below the drive
configuration.
i.
Proceed with the normal DOS procedure for
bringing up a hard disk using FDISK and
FORMAT commands.
See
your DOS manual for
further instructions.
Correct drive type
(YIN)?
Split into 2 logical units?
(YIN)
Enter drive defect table?
(YIN)
Is above information correct?
(YIN)
Ready to ERASE entire disk?
(YIN)
f.
If the drive type that you have is not listed
in the drive table, select table number 1 S
for FREE FORMAT. The following questions
will appear:
Cylinders (1.2048):
Ht!ads (1·16):
Step rate (micro sec): (default
=
(5, 10, 20, 30, 40, 50, 60, 70)
40)
Set Reduced Write Current at
(0 to Max CYlinders) (default
Cylinder:
NON E)
Set Write Precompensation at
(0 to Max CYlinders) (default
Cylinder:
=
NONE)
- 4 ­
- 5 ­