4gon RouterBOARD 411U Panduan Pengaturan Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Perangkat Keras Komputer 4gon RouterBOARD 411U. 4gon RouterBOARD 411U 2 halaman.

Extension Slots and Ports

●

One Ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X), so you can use either straight

or cross-over cables for connecting to other network devices. The Ethernet port accepts 9..28 V DC powering from a

passive PoE injector.

●

One miniPCI Type IIIA/IIIB port with 3.3V power signaling.

●

One miniPCI-e slot for 3G modem (onboard SIM connector for use exclusively with a miniPCI-e modem plugged in)

●

USB 2.0 port with 5V 1A supply

●

DB9 RS232C asynchronous serial port.

Buttons and Jumpers

ROS reset jumper hole (RESET) – resets RouterOS software to defaults. Must short circuit the metallic sides of the

●

hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place until RouterOS configuration is

cleared.

RouterBOOT reset button (S301) – loads backup RouterBOOT Loader firmware. Must hold button while booting. Use

●

in case operating system can't be booted and no useful information on Serial console output.

Operating System Support

Currently tested operating system is MikroTik RouterOS (starting from version 3.26).

part of it may be reproduced or transmitted in any form without prior written permission from the copyright holder.

RouterBOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered

trademarks appearing in this manual are the property of their respective holders.

Hardware. MikroTikls SIA warrants all RouterBOARD series equipment for the term of one year from the shipping date to be

free of defects in materials and workmanship under normal use and service, except in case of damage caused by

mechanical, electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or other

acts of nature.

If you have purchased your product from a MikroTik Reseller, please contact the Reseller company regarding all warranty

and repair issues, the following instructions apply ONLY if you purchased your equipment directly from MikroTik Latvia

To return failed unit or units to MikroTikls you must perform the following RMA (Return Material Authorization) procedure.

Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA process. Take into

account that all goods have one year warranty.

Manual. This manual is provided "as is" without a warranty of any kind, expressed or implied, including, but not limited to,

the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made every effort to

ensure the accuracy of the contents of this manual, however, it is possible that it may contain technical inaccuracies,

typographical or other errors. No liability is assumed for any inaccuracy found in this publication, nor for direct or indirect,

incidental, consequential or other damages that may result from such an inaccuracy, including, but not limited to, loss of

data or profits.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

rev. A (7-Jul-2009)