4healthcare 4H440 Panduan Instruksi Pengguna - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Instruksi Pengguna untuk Peralatan Medis 4healthcare 4H440. 4healthcare 4H440 15 halaman.
Halaman Cetak
Revision: IR
Date: 1 December 2021
13. Armrest Height Adjustment
The armrest comes set from the factory in the high position. It can be set to the low position
by following the instructions below.
Tools required; 17mm ring spanner & 5mm Allen key.
•
Use the Allen key to hold the swing up arm retaining screw from rotating whilst
undoing the screw retaining nut with the 17mm ring spanner.
•
Slide the armrest outwards and put aside.
•
Slide the top hole cover up past the holes in the frame as shown in the illustration.
•
Place the armrest assembly over the lower hole and slide the screw through hole,
place the saddle washer and nut onto the screw and tighten with spanner whilst
holding the retaining screw with the Allen key.
•
Note, make sure the stop pin is behind the frame when fitting the armrest assembly
to the frame.
•
Slide the hole cover down over the top hole in the frame.
14. Headrest Adjustment
6 Welsh Place Landsdale WA 6065
Website:
www.4healthcare.com.au
Use the three levers to adjust the
position of the headrest to suit the
user.
Tel:
(08) 9302 4757
Fax:
Email:
ABN 51 156 666 161
(08) 9302 4524
Page 12 of 15