DataApex Shimadzu LC-20 Manual - Halaman 17

Jelajahi secara online atau unduh pdf Manual untuk Pompa Air DataApex Shimadzu LC-20. DataApex Shimadzu LC-20 19 halaman. Metal free pump

Shimadzu LC-10/20 Pump

4.4 Shimadzu LC-10/20 Pump Setup

Shimadzu LC-10/20 Pump Setup

Configuration

type and set some other basic parameters.

Port

Sets the COM port to which the Shimadzu LC- 10/20 Pump pump is

connected.

Pump Model

Allows to select from several types of Shimadzu pumps. LC-10ADvp and

LC-10ATvp models are supported at the moment.

Note:

If any LC- 20 type pump should be connected, it is necessary to set the

LC-10 emulation mode on the pump (for more details see the chapter

Installation Procedure on pg 3)..

Valve Model

Allows to select the valve model that may be installed on the pump to

create low pressure gradient.

Sys Mode

Sets the pump operation mode. Isocratic and Low Pres. Grad. options are

available.

Note:

The pump hardware must be set accordingly (for more details see the

chapter Installation Procedure on pg 3)..

Solvents

Sets the number of solvents when the Low Pres. Grad. mode is used.

Max Pressure

Sets the maximum pressure allowance of the pump. This value is sent to

the pump and when the pressure exceeds this value, pump will react on it.

The pressure check is also present in Clarity, in the

Gradient - Gradient Options

dialog) is used to set the connection to the pump, select it's

Fig 10: Shimadzu LC-10/20 Pump Setup

dialog. Value of Max Pressure set there

4 Using the control module

dialog (accessible through the

- 13 -

System

Method Setup - LC