Addvent AVAC18X Petunjuk Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Kipas angin Addvent AVAC18X. Addvent AVAC18X 2 halaman. Air circulator range

Halaman Cetak
Safety Instructions
When using electrical appliances, basic safety precautions should
always be followed including the following:
1.
Use this fan only as described in this manual. Other use is not
recommended as it may cause fire or electric shock.
2.
This product is intended for household and light commercial use only.
3.
To protect against electrical shock, do not place fan in window, immerse
unit, plug or cord in water, or spray with liquids.
4.
Close supervision is necessary when any appliance is used near children.
5.
Unplug the fan from the outlet when not in use, when moving fan from
one location to another and before cleaning.
6.
Do not operate the fan in the presence of explosive and/or flammable
fumes.
7.
Do not place the fan or any parts near an open flame, cooking or other
heating appliance.
8.
Do not operate the fan with a damaged cord, plug, after a malfunction or
if dropped or damaged in any manner.
9.
Avoid contact with moving fan parts.
10. To disconnect, grip the plug and pull it from the wall outlet. Never yank
the cord.
11. The use of attachments is not recommended and may cause hazard.
12. Always use on a dry level surface.
13. Do not operate if the fan housing is removed or damaged.
Assembly
1. Unpack the fan from box.
The AVAC18X and AVAC20X models are fully assembled and ready for use
– please see 'operation' opposite.
2. The AVACP20 Pedestal fan needs to be assembled before use.
Remove the protective plastic film from the base plate.
G
G
Align and insert the black base tube into the base plate and tighten the
four screws (Figure 1).
G
Secure to the base plate and balance weight using the fixings provided
(Figure 2).
G
Insert the fan head socket onto the chrome tube and secure using the
fixings provided (Figure 3). The fan is now ready for use.
2
Figure 1
Figure 2
Figure 4
Figure 5
Operation
1. Set the fan on a level dry surface.
2. Check the rated voltage of the fan (220-240V~ 50Hz) is same as the power
source before plugging into the wall outlet.
3. On the AVAC18X and AVAC20X: turn the switch clockwise (Figure 4) to
desired speed settings (0 = OFF, 1 = LOW, 2 - MED, 3 - HIGH).
On the AVACP20: turn the switch clockwise (Figure 5) to desired speed
settings (0 = OFF, 1 = LOW, 2 = MED, 3 = HIGH).
4. Adjust to your desired air stream direction by tilting the fan to the required
position.
3
Figure 3