ELRO AS80MA11 Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Sensor Keamanan ELRO AS80MA11. ELRO AS80MA11 4 halaman. Magnetic detector

Testing

(1) Go to System, and select ARM

(2) Wait for 30 secs, then separate the detector from the magnet (at least 3.5cm

distance apart).

(3) If the test is successful the system will trigger an alarm (alarms are listed in

"Events").

Notes: It is necessary that the system is powered and connected to internet.

(4) If the test is unsuccessful, please check the troubleshooting section.

Mounting

1. Mount the Magnetic Detector in dry interior locations only.

2. Do not place the unit near combustible substances or any source of heat, e.g.

fires, radiators, boilers etc.

Note: Mounting the detector to a metal frame or within 1 meter of metalwork (e.g.

radiators, water pipes) may affect radio range of the device. Please use plastic or

wooden spacers to separate the detector and metal surface when required.

Installation

1. Fit the magnet on the moving part of the door / window opposite the detector (or

vice versa, if necessary). Use the provided self-adhesive tape to secure them in

place.

2. Make sure the parallel gap between the magnet and detector is less than 20mm

and that they are aligned. An alarm will be triggered if the gap is greater than

35mm.

3. Perform the test using the same steps described in Operation & Testing section

above to ensure the unit is working properly.

Maintenance

1. Low Battery: When the battery becomes low, the detector will report back to the

gateway every 20 minutes. If the door or window is open the LED will flash to

indicate low battery condition to the user.

2. If the battery needs to be changed, please insert the batteries at a 45° angle as

shown below.