DataComm D33.6 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Modem DataComm D33.6. DataComm D33.6 12 halaman. Dial-up modem d-series

AT YOUR COMMAND >> CN<Enter>

CONFIGURE NETWORK

-------------------------------

SYNC MODEM

LEASED LINE

ERROR CORRECTION ON

SYNC or ASYNC modem? [S/A] >> A<Enter>

ASYNC rate? [9600 / 19200 / 38400 / 57600 / 115200] >> 57<Enter>

Leased or Dialup Line? [L/D] >> D<Enter>

Enable Error Correction? [Y/N] >> Y<Enter>

Disconnect timeout? [1 to 99 min; 0=Disable] >> 0<Enter>

One-Touch Dialing? [ATDS0 / DTR Dial / OFF] >> AT<Enter>

Send SR call progress messages? [Y/N] >> Y<Enter>

ASYNC MODEM: 57600

DIALUP LINE

ERROR CORRECTION ON

Configure Modem? [Y/N] >> Y<Enter>

*** CONFIGURE MODEM - Type ESC ESC to stop

at<Enter>

at&f &q6<Enter>

at&z0=nnn-nnnn<Enter>

at&w<Enter>

*** End CA/CC Capture

AT YOUR COMMAND >>

To make a connection to the host press <space> or <Enter> from any

terminal connected to the remote multiplexer. When you see "SR:

Connected..." you should be able to log in from all remote terminals.

If you set the remote multiplexer Disconnect timeout to a number

from 1 to 99 (minutes), the connection will hang up if there is no

activity to or from any terminal for that period of time. To

reestablish the connection, type <space> or <Enter> from any

terminal.

REMOTE MULTIPLEXER

Note: Replace nnn-nnnn with the phone

number of the HOST Multiplexer.

ONE-TOUCH DIALING