Elsema AXIOM iS900 Series Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Elsema AXIOM iS900 Series. Elsema AXIOM iS900 Series 16 halaman. Sliding gate opener
Halaman CetakE. GEAR RACK INSTALLATION
1. Move the Gate leaf to fully closed position.
2. Place the first piece of the rack over the pinion leaving about 1.5mm gap and mark the
drilling point on the gate, drill a pilot hole and screw the rack using the self-tapping screw
with the reinforcing plate.
3. Move the gate manually, making sure that the rack is resting on the pinion and fix all
other screws.
4. Bring the next rack and join it to the previous one by slotting it into inter-connecting slots.
5. Repeat this process until the gate is fully covered from fully open to fully close positions.
F. CHECK GEAR RACK INSTALLATION
Make sure that the rack is constantly in full contact with the pinion for the full open and
close travel cycle.
Manually check if the gate reaches the mechanical stop limits and make sure there is no
friction during gate travel.
Do not use grease or other lubricants between rack and pinion
AXIOM SLIDING GATE OPENER MANUAL
7